Rod hanger modeling with PTFE between pipe and the clamp - Intergraph CADWorx & Analysis

You are not logged in. [Log In] Home Page » Forums » Analysis Solutions » CAESAR II » Rod hanger modeling with PTFE between pipe and the clamp

Topic Options

#76744 - 10/16/22 06:11 PM Re: Rod hanger modeling with PTFE between pipe and the clamp [Re: Van Ha]
Van Ha Member Registered: 07/29/09 Posts: 195 Loc: Ho Chi Minh City, Vietnam	I don't think there is confusing here. This is existing support, and it slides through the clamp. Any other comments?
Top

View All Topics

Entire topic
Subject	Posted by	Posted
Rod hanger modeling with PTFE between pipe and the clamp	Van Ha	10/16/22 11:05 AM
Re: Rod hanger modeling with PTFE between pipe and the clamp	mariog	10/16/22 01:55 PM
Re: Rod hanger modeling with PTFE between pipe and the clamp	Van Ha	10/16/22 06:11 PM
Re: Rod hanger modeling with PTFE between pipe and the clamp	Richard Ay	10/17/22 07:29 AM
Re: Rod hanger modeling with PTFE between pipe and the clamp	danb	11/02/22 08:46 AM
Re: Rod hanger modeling with PTFE between pipe and the clamp	danb	11/02/22 10:07 AM

Moderator: Denny_Thomas, uribejl

0 registered (), 40 Guests and 1 Spider online.

Key: Admin, Global Mod, Mod

May
Su	M	Tu	W	Th	F	Sa
			1	2	3	4
5	6	7	8	9	10	11
12	13	14	15	16	17	18
19	20	21	22	23	24	25
26	27	28	29	30	31

Forum Stats

12065 Members
14 Forums
16973 Topics
75151 Posts

Max Online: 303 @ 01/28/20 11:58 PM

Top Posters (30 Days)