Dear all
For a Division 2 vessel, Straight Face of a Cone to Flange joint is modeled as a cylinder and analyzed for Combined loadings as per 4.4.12.2.
As a result, Below warning occurs since LamdaC is exceeding 1.2. However the PV Elite report does not show how the LamdaC value is calculated and what are the parameters used to calculate LamdaC. Is any option available in PV Elite to see the detailed report?

Warning : One or values of LamdaC exceeded 1.2. Please check paragraph
4.4.12.2(h) in ASME VIII-2 for more information

Thanks and Regards
John