The newest Global Coordinates window shows all discontinuous pipes' origins as origin node number, x coord, y coord, z coord.

While it's open, it's impossible to interact with the model as the Global Coordinates focus dictates it closes, first.

It can be a bit of a chore to chase down individual node numbers to verify they're where they belong.

I think it could be further enhanced. Initially, I'd suggest also listing the line number (which I'm going to go chase down an ISO to check against). But I suppose if there were a feature that would just display only the node numbers of these origins, that might help, too.

Other ideas are welcome.

Also, it's good to have "OK" "Cancel" but also "Update" option. I'm on the fence whether or not "Cancel" should undo all changes "Update" actions would perform, but that'd be the most logical.