Hello "dgorsman"!

Since working here, local administrator privileges are mine: I can install software as-needed. I must say that at this point in the thread especially, your interest and suggestions are very much appreciated.

PAST SUCCESS
The ISOGEN tool was successfully run in a prior CADWorx/BricsCAD version pairing in a demo setup (when I had support) at the beginning of 2019.


WINDOWS REGISTRY
Very cautiously and with past success as a forced techie (solving my own CAD-related issues as my IT colleague is overloaded and non-CAD based), I have tweaked the registry with online guidance or watching support do the same.
QUESTION: Are there any specific registry locations that might cause this issue?