Hey guys,

This is the first time I've gone through using the API 610 module in Caesar so I'm sorry if this is obvious.

Attached is an excerpt of the output. On page 1 the base Table 5 values and load comparisons make sense (ie, everything with ratio > 1.0 failed). On page 2, the Table values are modified with the 2.0 modifier. Some of the ratios here still exceed 1.0 but say pass (highlighted).

Does this make sense? I was under the impression that when using Annex F of API 610, the individual loads (seen on page 2) still can't exceed the 2.0 multiplier for Table 5.


Thanks