Hello Folks,

I am working on a problem and there are 2 different sizes of spring hangers located at the same location. This is a vertical run of pipe supported by spring cans through trunnion. My question is why there are 2 different size spring cans selected for the same location. I could not find the previously done stress analysis on this piping, but even if I let the CAESAR-II to reselect the springs, it is doing the same, i.e selecting 2 different sizes of the springs.
Could the experienced forum members assist me regarding this issue, If it is okay to have 2 different sizes spring cans at the same location. If not how can I force CAESAR-II to select the same size spring cans.

I hope I am making sense.

Regards