Hi,
I've finished up a decently large analysis for a client, and we usually plot out an image of the overall model, and then more close up images with node numbers at the restraints and hangers, as we reference them in reports that we put together for the client.

The issue I'm having is that this particular new system is fit between two old systems, which I was required to model for proper analysis. It's nearly impossible to get a good view of the new piping system with the existing piping in the way - So I go into line numbers, select the existing piping, give them a designation, and hide them, leaving only the new piping in view.

Unfortunately, when I turn off the view of the existing lines, and select to show node numbers at hangers, anchors, restraints - I also see all the node numbers for the existing piping. There are enough supports on the existing lines to really make these images too busy to be useful as a node map. I can select "All" node numbers, and it will show all the nodes on the new piping and none on the existing...

I tried using node names as a workaround - I went through and named all of the nodes I wished to see, I just named them their respective node numbers - but they don't show up at all when I hit 'names only.'

Is there something I'm missing?
Scott