Dear Friends, Richard and Dave,

We are using CAESAR II 2014, VER 7.00.00 2800 (BUILD 140416)

While using "Distance Calculator" to measure distance from one node to other node, its very good facility is provided in new version.
Thanks,

However, once we finished the measuring distance, still the "arrow is to measuring distance" will continue, not able to close.

Until, I will close the CAESAR Input spreadsheet, again open than only closing.

Do I need some set up in Configure set up ?

The command is continue open, not able to finish. We had tried various CAESAR Files in other PCs also, but same problem.
Can you please help us ?

Regards
SND