Sir Richard,

Thanks for your reply,

1. For example: User entered WC value 0.5 (BY MISTAKE) & from the table CAESAR-II interpolated value is 0.95 (CORRECT VALUE) then for calculation of minimum thickness value which WC value is used by CAESAR-II?

2. Code given a DEFINED VALUES to WL based on temperature and material then again why CAESAR-II given this option to user to enter WL. Is there any reason behind that? CAESAR-II can automatically do this interpolation and take that WL value.

3. I think “The value of WC should be equal to WL”, whether these values are varies to each other in any case? Because both values are taken from the table 302.3.5 by interpolation based on material and temperature.