Sir Dave,
Thanks for your reply,
1. Is my understanding is correct.
If selected then WL varies from (null) i.e., 0 to 1.
If not selected WL=1 ALWAYS.
2. If selected (seam welded) then WL value from where it is taken?
3. Where this WL is used in CAESAR-II calculations. (From last post you said thickness. But where that thickness is used, because user already entering the thickness value.)
4. CAESAR-II is taking the value of WC automatically from the Table 302.3.5 WELD JOINT STRENGTH REDUCTION FACTOR, then why not WL.
Please correct me if I am wrong.
Edited by durga (03/31/14 09:52 PM)
_________________________
Thanks,
Durga