Thanks, received this and a quote for the new tablet.

CalComp VI Model 1212, with 16 button mouse.

The DrawingBoard VI is fully compatible with any Windows operating system, up to and including Windows 8 32/64-bit. However, our tablet driver (TabletWorks 10.xx) is not recommended for use with AutoCAD software. Please review the following information about using the DrawingBoard VI with AutoCAD. Please note that Autodesk is not one of our software partners, and questions about tablet/digitizer support in AutoCAD should be directed to Autodesk technical support.


Beginning with AutoCAD 2009, AutoCAD requires a Wintab 1.1 compatible driver. TabletWorks only supports Wintab 1.0, and it is not compatible with current versions of AutoCAD. Please review the below information about setting up your digitizer with AutoCAD:


Remove TabletWorks and install the vTablet driver provided by Digitizer Technology Company. Available at www.vTablet.com.
Your tablet must be connected to your PC using a serial connection. The vTablet driver does not support USB. If your PC does not have an available serial port, we recommend using the Keyspan USA-19HS serial-to-USB adapter.
If you do not have the serial cable and power supply for your digitizer, you may contact our sales staff to order them.
The digitizer should be set to its default configuration setting.
TabletWorks may provide limited compatibility with some earlier versions of AutoCAD. For full compatibility, you should use vTablet.
Please note that vTablet and AutoCAD are third-party software products, and we do not provide technical support for issues with those programs.


I purchased the vTablet 7.11 driver last year to run ACAD2013,Win7 64bit and on my crusty old Summasketch III.

So us dinosaurs out there can still use a new tablet and 16 button mouse.

Thanks for the dialog,

RDO