Dear Sir,

We are currently using ver 6.1 for stress analysis, we had not used Ver 5.3, hence we are not aware for Ver 5.3 new addition. like "Nozzle Check".

Our nozzle axis is in "Y" direction, equipment is "X" direction, after putting the allowable as per "A","B","C",still CAESAR Nozzle Check shows only "Y" load. CAESAR not checking in X, Z direction loads-moments.

We checked the CAESAR input methods, but no detail has been given.

Can you please help to short out this problem?

IS CAESAR checking only Axial Load of Nozzle in Force-Moment in Nozzle Check Module?

Thanks in advance