Hi Miyamoto,

ok, I did it before, but if you see the vendor just sent me the lateral stiff. So, I took the CAESAR manual and he teach how can we model when vendor send us lateral or bending stiff.

Look at the picture attached.

So, I have an universal EJ and just lateral sitff. I think that if I use the modeler EJ at CAESAR, considering an Universal EJ I will take two bellows and one piece of pipe between of then, and I don't know if I can put the lateral stiff both of then too.

If I understood I just do it if the vendor send me the bending stiff.

Please, let me know if I'm correct...let discuss abou that...what do you think ? I need it urgently because I will buy this EJ and I need to evaluate that in my model.

Thank you very much Miyamoto.

Best Regards,

Saulo Cunha