nominal thickness and finished thickness - Intergraph CADWorx & Analysis

You are not logged in. [Log In] Home Page » Forums » Analysis Solutions » PV Elite » nominal thickness and finished thickness

Topic Options

#52107 - 12/12/12 03:37 AM Re: nominal thickness and finished thickness [Re: princeR]
vishaltailor Member Registered: 05/15/10 Posts: 56 Loc: Gujarat, india	Mayank You may be right. But, it see details output of PVELite with and without nominal thk for ellipsoidal d'end. Hope you will surely observe difference in MAWP values in both case. _________________________ Thanking you & with regards Vishal Tailor
Top

Entire topic
Subject	Posted by	Posted
nominal thickness and finished thickness	princeR	03/22/12 01:27 AM
Re: nominal thickness and finished thickness	KunalShah	03/22/12 01:29 AM
Re: nominal thickness and finished thickness	princeR	03/22/12 01:37 AM
Re: nominal thickness and finished thickness	zul	04/04/12 09:17 PM
Re: nominal thickness and finished thickness	vishaltailor	04/09/12 12:24 AM
Re: nominal thickness and finished thickness	zul	04/13/12 09:07 PM
Re: nominal thickness and finished thickness	vishaltailor	04/18/12 02:57 AM
Re: nominal thickness and finished thickness	mayank	11/06/12 10:17 AM
Re: nominal thickness and finished thickness	vishaltailor	12/12/12 03:37 AM
Re: nominal thickness and finished thickness	jprashant31	01/27/13 01:23 AM
Re: nominal thickness and finished thickness	Static_eng	03/02/13 11:28 AM
Re: nominal thickness and finished thickness	mayank	07/25/13 11:20 AM