Thank you.

Interesting, this version came just when we decided to use pcf files instead the classic way.

Until now I was not very sure that it would be a good idea, for the reasons we know.

But... On one project we have to issue the preliminary stress calculations for another office that use SP3D, while we don't yet. Unfortunately the isometrics can not be extracted at this stage, the lines have slopes that we have to consider so it would be a nightmare to draw sketches looking in SP Review (one available licence for six stress engineers as the others SP Review available licences are incompatible versions).

With a tight dead-line, the only reasonable thing to do was to use the pcf files.

Whis gave us the possibility to do our work and we will finish in time.

I think this can be considered a Success Story.

I know that there are many things to investigate, but is a good start.
I can barely wait to see the new interface and I am interested to know as much as possible about it.
I'm interested also in developing the supports map file.

Best regards,