See the example underneath:

CAESAR II Ver.5.20.3, (Build 100715)

RESTRAINT SUMMARY EXTENDED REPORT: Loads On Restraints
Various Load Cases

LOAD CASE DEFINITION KEY

CASE 5 (OPE) W+D1+T1+P1+H
CASE 6 (OPE) W+D2+T2+P1+H
CASE 7 (OPE) W+D1+T3+P1+H
CASE 51 (OPE) L51=L5,L6,L7

Filters Used:
Node Number >= 30394 and <= 30394
Show All Restraints


NODE
30394 Rigid Y w/gap; Rigid+Z
FX FY FZ 5(OPE) 967 -700 -3978
6(OPE) 1145 -2272 -3851
7(OPE) 967 -700 -3978
51(OPE) 1145 -2819 -3978

As it can be seen above, load case 51 for node 30394 is defined as the maximum of L5, L6 and L7 and it should be -2272 for FY. Instead -2819 comes out. Almost all outputs that I get from my CAESAR happen to have some errors like this. Same thing with displacements.

Anybody happened the same?