Hii,

I am using Caesar-II 5.3 version.... During isometric drawing generation of a model i m getting some problem...

Example:- Node:- 10-20.DX:-1000mm

then bend option given at node 20.

Angle1:- M Node1:- 19
Angle2:-0.00 Node2:- 18

Node:- 20-30. DY:-1000mm

After this Put anchors on Node 10 & Node 30.

Creating Isometric drawing, with editing sterss annotations, having features of Input for NODE NUMBERS & BEND DATA.
In Isometric drawing, is there any default settings to remove the mid point node numbers as well as the bend angle.?? i.e. Is there any option to not have the mid point and mid bend angle in isometric drawing??


Plz provide me the solution for the above issue.


regards,
Ashutosh