Dear sirs:
When we checked the nozzle loadings of the static equipments,we found the actual nozzle loadings are higher than the allowable laodings given by the client.So we use wrc107 to check
the stress,if the result is pass.Do you think if it is necessay to transmitte the higer loadings to the vendor.
Since I am a piping stress engineer rahther than an equipment engineer,I do not konw the stress catageory of the equipments very clealy.(such as Pm,Pl,Q and so on)Could you give me some advice.and do you think we sholud include the pressure trust when do the elastic analysis of nozzle with wrc107?Why?
Thank you!