Hi everyone,
I am going the slug flow analyis.The problem i am facing is below.
1.when i follow the tutorial in Caesar manual of water hammer to do slug analysis and using inbuilt module of Water hammer/Slug Spectrum i am able to run the results without error.I dont knw weather results are correct or not.
2. when i use the same input and select time history analyis the following error message pops up.
03.6265 , 1.0090
249.9998 , 1.0084
*** ERROR ***
Data in Time History profile: NODE710
referenced in dynamic load case 1 must be TIME vs FORCE.
*** NOTE *** Input check terminated due to fatal errors
Can someone tell which method is correct and how do i remove this error
3.Do i have to enter my time force profile in DLF/Spectrum generator and get the frequency DLF curve or simply enter it in Enter/Edit Spectra data.(these are two icons at top adjacent to Relief load syntheesis)