@Nald

1)Ya i called the third load case for the hanger by going in hanger design control data in model option in input spreadsheet, and checked on "Calculate actual cold loads" , is that correct? my hanger output report is showing vertical movement of 0.75in. why then actual is same with theoretical installed load?

2)in which report weight will be shown after including WNC load case??


3) The initial load case of hanger design which is "restrained weight case" calculates dead weight . This case usually includes weight, pressure and concentrated loads . this is written in technical manual .
As there is no temperature involved , i was wondering why they have used term "hot load" for restrained weight case.????
Nald kindly guide

Regards.