Dave Sir,

Thank you very much for the reply. I understood your justification.

I purposefully put the question in the forum instead of addressing this to PRG support, as we all know that most, if not all, of the NozzlePro users use Caesar-II also. So, getting reply will be quicker & better in quality.

We, the users of NozzlePro, know that it is very useful template-based FEA modeler that also compares calculated stresses to Code-defined allowable limits. Elsewhere, in any general purpose FEA software, analyst can make the FEA results opaque to the people who do not understand that particular FEA software.

regards,

sam