Is it not right to use spring near equipment - small Y disp

You are not logged in. [Log In] Home Page » Forums » Analysis Solutions » CAESAR II » Is it not right to use spring near equipment - small Y disp

Topic Options

#32649 - 01/18/10 03:28 AM Re: Is it not right to use spring near equipment - small Y disp [Re: sam]
shr Member Registered: 02/16/07 Posts: 508 Loc: Singapore	Hi Sam I don't believe that there is anything wrong to use spring close to equipment nozzle to reduce nozzle load. However WNC case need to check to avoid overload on nozzle for installation/shut down situation. Regards Habib
Top

Entire topic
Subject	Posted by	Posted
Is it not right to use spring near equipment - small Y disp	sam	01/17/10 11:24 PM
Re: Is it not right to use spring near equipment - small Y disp	shr	01/18/10 03:28 AM
Re: Is it not right to use spring near equipment - small Y disp	Bob Zimmerman	01/18/10 10:26 AM

Moderator: Denny_Thomas, uribejl

0 registered (), 75 Guests and 2 Spiders online.

Key: Admin, Global Mod, Mod

Forum Stats

12065 Members
14 Forums
16973 Topics
75151 Posts

Max Online: 303 @ 01/28/20 11:58 PM