Trouble in orientation of the nozzles - Intergraph CADWorx & Analysis

You are not logged in. [Log In] Home Page » Forums » Analysis Solutions » PV Elite » Trouble in orientation of the nozzles

Topic Options

#31503 - 11/19/09 04:32 AM Re: Trouble in orientation of the nozzles [Re: Abhilash]
Kinge Member Registered: 03/03/09 Posts: 43 Loc: Netherlands	Answer on you question number 2. You can calculate with appendix 2 a Blind Flange in Pvelite. I dont know if you have CodeCalc its customer-friendly to use then Pvelite to calculate a blind flange or other flanges.
Top

Entire topic
Subject	Posted by	Posted
Trouble in orientation of the nozzles	Abhilash	11/13/09 02:57 PM
Re: Trouble in orientation of the nozzles	Abhilash	11/16/09 04:19 AM
Re: Trouble in orientation of the nozzles	Abhilash	11/18/09 05:47 AM
Re: Trouble in orientation of the nozzles	Mandeep Singh	11/18/09 08:56 AM
Re: Trouble in orientation of the nozzles	Abhilash	11/19/09 03:37 AM
Re: Trouble in orientation of the nozzles	Kinge	11/19/09 04:32 AM
Re: Trouble in orientation of the nozzles	Ray_Delaforce	11/19/09 09:09 AM
Re: Trouble in orientation of the nozzles	Abhilash	11/21/09 01:48 AM
Re: Trouble in orientation of the nozzles	Abhilash	11/21/09 01:49 AM