I finally got the 5.2 on my machine now. When I tried to run the WRC 107 analysis, I noticed that in the INPUT ECHO report, the part where internal pressure should be is missing, which should be around the red line.
Could you any one tell me how to fix this? Thank you very much.

===============================================================
INPUT ECHO
----------
Description:
FAD01_NE_091014

Vessel Type: Cylindrical
Vessel Node Number: 0
Vessel Diameter: ID 2216.000 mm.
Vessel Wall Thickness: 142.000 mm.
Vessel Corrosion Allowance: 3.200 mm.

Vessel Material Name: SA-516 70
Vessel Working Temperature: 375.000 C
Vessel Cold Allowable Stress: Smc 137892.000 KPa
Vessel Hot Allowable Stress: Smh 121632.680 KPa

Attachment Type: Round Hollow
Attachment Node Number: 0
Nozzle Diameter: ID 131.700 mm.
Attachment Wall Thickness: 80.150 mm.
Attachment Corrosion Allowance: 3.200 mm.

WRC107 Stress Concentration Factors included
Stress Concentration Factor (Nozzle-Vessel): Kn 1.000
Stress Concentration Factor (Nozzle-Vessel): Kb 1.000

No Vessel-Nozzle Dirrection Cosines were defined.

External Loads input in local WRC107 convention

++++++++++++++++++++++++++++++++++++++++++++++++

WRC107 Version/Year March 1979 Use B1&B2
Use Interactive Control Yes
Include Pressure Stress Indices per Div.2 No

Calculate Hoop Stress based on (from config): ID Diameter
Calculate Longitudinal Stress based on (from config): Lame Equation
===============================================================