Regarding the WRC 107 module of Caesar Ver. 4.5, it is observed that :
1)The allowable stress intensities of vessel material correspond to the allowable stress values (i.e. the specified default Caesar values are UTS/3.5 instead of UTS/3).
2)The WRC 107 check does not ask for nozzle material allowables (in case found lower than vessel shell material allowables) which could be used as allowables for nozzle to shell junction calculated stresses.
3)Further, I would kindly request to have your feedback as to whether the WRC 107 run associated with Caesar Ver 4.5 would generate similar results when compared with those associated with vessel design packages like Codecalc & PVElite for a particular set of inputs.

Would appreciate your advice & clarification on the above.
Thanking you.