Another elementary (silly?) question for seasoned CII users.

I have couple of "undesigned" hangers in my model. In the load case editor, if I have the 2 default hanger selection cases as W and W+D1+T1+P1, I am getting a warning message that "hanger loads exist in the model but were not included for hanger restrained weight (/operating) run". The message vanishes if I include H in above load cases.

I have checked over and over again that I do not have predefined hanger loads in the model (I have even removed all the hangers and included them back again).

The hanger selection/output is identical in both cases - when I run the analysis ignoring the warning (and without H) or when the load cases have H added.

Can somebody please explain?

cheers,