Hi,

When I'm generating stress-iso form Caesar II the Isogen has split whole pipline-system into few parts of stress-iso drawings. And it's ok. But problem is when pipeline-system is long/developed (number of output drawings is grater then 4). Then Isogen is split it into 2 or more different stress-isos (each of it have maximum 4 drawings). It's not good cause the drawing numbering is different and not common.

For example output names of DWG files for pipeline-system named Z03_03 are:
Z03_03.dwg (page 1 of 4)
Z03_03A.dwg (page 2 of 4)
Z03_03B.dwg (page 3 of 4)
Z03_03C.dwg (page 4 of 4)
Z03_031.dwg (page 1 of 2)
Z03_031A.dwg (page 2 of 2)

So you see that there is 6 drawings but numbering it's not common.

And my question is: is it possible to have influence on Isogen split operation to have continuous drawings numeration (for showing example: from 1,2,3.. to 6) ???

Thank you for any answer,

Regards,
JK