This post from Vanman 5/15/07 Titled Cadworx Error

---------------------------------------
check out CADWorx error 2012


The piping coordinates which the previous function tried to use are beyond the limits allowed by CADWorx and AutoCAD. The solution to this problem is to draw the piping system closer to a 0,0,0 coordinate. If this is an existing piping drawing, move it closer to 0,0,0 and then mode convert. You must mode convert the drawing to re-create the coordinate data stored within the components after a move. If you have any bolts in the system, erase them before you move the system. Bolts can be re-inserted into the system with the AUTOBOLT command.

CADWorx coordinate limits are -9,000,000 to 99,000,000 units (negative nine million to positive ninety nine million units)

In imperial coordinates, the limit is approximately: -750,000 feet to 8,250,000 feet (negative seven hundred fifty thousand feet to positive eight million two hundred fifty thousand feet)

In metric coordinates, the limit is -900,000 meters to 9,900,000 meters (negative nine hundred thousand meters to positive nine million nine hundred thousand meters)
_________________________
Cadworx User

-----------------------------------