Hi..can anybody please guide me wether it's possible to model Reducing Elbows in Caesar. If yes..which is the relevant CAESAR II manual to be referred.
Thanks Richard for your reply. I have a bit of confusion on the 'breaking the elbow' thing. Can u pls get it to me in detail. from what i understand the normal break command cannot be applied. Do i have to model two 45 deg. elbows as a typical mitered elbow. One piece of the first size of 45 deg. and the next piece of the second size of 45 deg.
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
Yes you would model the elbow as two 45s instead of one 90. However, you would not specify it as mitered. You are breaking the elbow numerically, not physically.
_________________________
Regards, Richard Ay - Consultant
Can i send you a sample model, done as per your instruction. If you could advise me on the correctness of method followed, it would be helpful. If yes, can I have your email address pls.