Hi!

I'm using the version 12 of the software CAESAR II and I have observed that the input window can't be maximized in order to extend it to both screens which is pretty uncomfortable since you have to "extract" elements of the input window to the other screen in order to obtain a decent area for the 3D Model. And every single time you run the calculation or run the check error or just open the load case editor.., you will need to "extract" the input piping element again and again and again.

Is there any option to fix this in order to have the same capability of the previous versions?

Thank you very much

Regards

Unfortunately this happened several versions ago, when we upgraded the toolkit we use to generate the menus and toolbars. We have contacted the vendor/developer about this problem. Hopefully in their next release they resolved this issue.