anyone experience this on CII 2019?

when batch run was activated attach picture will show then CII closes without performing analysis.

What happens if you perform Error Checking, then (assuming there are no errors), close the input module and start static analysis from the Main Menu?

If the Static Analysis module (where you define load cases) does not start, can you start the Configuration module?

Hi Richard,

Same thing happen when I just do the error checking.

Regards,

In addition, yesterday the model runs smoothly.

This morning this happens and not just this model. I've tried running other files and same happens too.

The reason I asked about the Static Analysis and Configuration modules is because those two are dependent on ".Net", which has caused issues in the past.

The obvious question is "what changed on your machine to cause this issue"?

To save time in resolving this issue:
1) Please make sure you're running the latest Service Pack for your version of CAESAR II.
2) If that doesn't resolve the issue, please open a Support Request on Smart Support.

Hi Richard,

I am running CII 2019 SP1 (11.00.01.2300) (build 191202).

Also nothing has change on my machine, except those updates from microsoft.

Anyway I did try to tweak/change the databases for valve and expansion joint on configuration file and it did run analysis again.

Thanks....