I like to use the graphical output processor and select an element to check the stress and displacement at a specific location for a specific case. I'm noticing a problem doing that in CAESAR II 2019 when I exclude some cases in the load case setup.

In the attached simplified example, I have
L1: T1
L2: T2
L3: T3 (excluded)
L4: T4
L5: T5 (excluded)
L6: T6 (excluded)
L7: T7
L8: T8

Expected displacements at node 30:
L1: 0.0233"
L2: 0.1045"
L4: 0.2812"
L7: 0.5746"
L8: 0.6833"

As shown in the video below, L1 and L2 are okay. But when I try to see the displacements in case L4, it's still stuck on L2. When I try L7 and L8, it goes to L4. The only culprit I can think of is the fact that I have cases L3, L5 and L6 excluded.

Maybe some of you can try it for yourself with the attached file.

I should also add that if I include all cases, I saw no such peculiarity.

Faizal,

Could you please file an SR on this issue?

Yes I did. Thank you.