Dear Mr. Magliolo,
thanks for Your reply.
I noticed that when I select one of the above mentioned settings, Hanger table displays the selected manufacturer; instead after run stops and I open input the Hanger table is blank!
If I select manufacturer at this time, it seems that run works fine!
I noticed another issue:
- If I click on "Extended range", I can't engage this setting;
- Insted if I click on "Cold load", the setting engaged is "Extended range"; after second click on "Cold load", "Extende range" is disabled and "Cold load" is engaged;
- If I click on "Hot load centered", this setting is not engaged but both "Extended range and "Cold load" are engaged; after second click on "Hot load centered", "Extende range" is disabled and both "Cold load" and "Hot load centered" are engaged"; at the third click, both "Cold load" and "Hot centered load" are disabled and "Extended range" is engaged; at fourth click "Hot load centered" is engaged and the other settings are disabled.
Our three workstations feature this issue and the fatal error.
Thanks.
Best regards
Alessio
Edited by Alessiaccio (07/02/19 01:48 AM)
_________________________
La potenza e' nulla senza controllo.