Topic Options
#72164 - 09/12/18 10:13 AM Olet on Existing Header
sylv7320 Offline
Member

Registered: 06/02/15
Posts: 96
Loc: USA
Does anyone have a procedure for getting an olet tie in to an existing header of a different line number to iso properly with continuations and reference coordinates?

I've tried several scenarios using different combinations of line numbering on both sides, with/without weld, isogen continuation graphics counts, and can't get an iso with a new olet tying into an existing header (shown dotted) showing the continuation callout to the existing header line number and a coordinate.
_________________________
Whether you think you can or you think you can't, you're right.

Top
#72165 - 09/12/18 11:01 AM Re: Olet on Existing Header [Re: sylv7320]
jgarza0422 Offline
Member

Registered: 11/16/11
Posts: 11
Loc: Houston, TX
What I have done is make the existing pipe that the olet is on the same line number and then drop the iso. Depending on how many extra fittings you have you might have 2 callouts with the existing line number. you just have to delete one of them.


Edited by jgarza0422 (09/12/18 11:02 AM)

Top
#72167 - 09/13/18 06:34 AM Re: Olet on Existing Header [Re: sylv7320]
MattCB Offline
Member

Registered: 11/22/06
Posts: 680
Loc: Wichita, KS
Make the header the same line number as the olet. Set it as existing and dotted undimensioned. Add a 2nd short pipe to the header with the continuation line number.

Top



Moderator:  Dominik Hepp 
Who's Online
0 registered (), 25 Guests and 2 Spiders online.
Key: Admin, Global Mod, Mod
November
Su M Tu W Th F Sa
1 2 3
4 5 6 7 8 9 10
11 12 13 14 15 16 17
18 19 20 21 22 23 24
25 26 27 28 29 30
Forum Stats
11555 Members
14 Forums
15615 Topics
70269 Posts

Max Online: 126 @ 05/09/18 04:29 PM