Hello Mandeep,
Could you please give me your email? and I will attach and send to you. I am using two version of Caesar II (Version 8.0 2016 and version 10.0 2018).
I did model in version 8.0 and translate to version 10.0 and then using API 610 module to verify nozzle loads.
Hello Dave,
When I imported the load case from Caesar II to API 610 module and I saw the coordinates were global (It appears capital letter). And then I check the reports at the "Nozzle Allowable - Table 5" (It appears lower case)and I compared the value in the table and found that the comparison between fy, fz and my, mz were not proper.
Thanks both of you for looking about the concern.