I am using CadWorx 2013 R1 and I am trying to place a slope line with slope of 7mm in 1m. and I am unable to place the same due to following error message, "Angle of bent that will be created is too small..."

Try placing a tee and then connect pipe with S slope, m meter, m meter, 7


Please advise,
Thanks,
FRS

It could be that your trimmed elbow rule is turned off and hence not allowing you a shallow angle.

are you using the pipe router or changing the ucs?

I'm getting the same problem. My trimmed elbow is turned to automatic and I'm using the the pipe router. Any suggestions?

Not sure if this topic is dead or resolved, but what angle are you trying to trim your elbow too? also what spec are you using?

Possibly a bend or a miter would work better. An angle of less than 8 degrees makes end preparation of the trimmed elbow a challenge.

The way to go workaround with this issue is to make line from start point CL of 1000mm length and then go up or down 7mm with line (+ or -). Now you have 7mm per meter, create pipe from start point and use SKEW (K-shortcut) and snap it on that second point. And then you have your slope. Works perfectly. Isometric too.