Dear Richard/Dave,
For heat exchanger, With Anchor stiffness – Loads are very high— Ex: LOADS 1
I used NOZZLEPRO/WRC 297 nozzle flexibilities, then loads are reduced – Ex: LOADS 2
Both LOADS 1 & LOADS 2 exceed the allowable. I want to run NOZZLEPRO to check local stresses.
Now my question- can I use the LOADS 2 (NOZZLEPRO/WRC 297 nozzle flexibilities used) in NOZZLEPRO to check local stresses.
If I used LOADS 2 in NOZZLEPRO, I am using flexibility twice, in C-II and in NOZZLEPRO(in built flexibility used).
Please correct me, If I am wrong
_________________________
Thanks,
Durga