Esteemed experts,
when I select my custom summary report for NC-3658.3 flange
check created in Caesar 2014 (build 150704), the output
window does display the message "Report contains no data
to display".

The same message is displayed during the creation of this
custom report.

I created the same report in Caesar 2011 (build 120525) and
it works fine, so I imported it in Caesar 2014 but I see the same bad message on screen.

Please, can You explain me how to fix this issue?

Thanks

Best regards

You are required to explicitly specify which yield stress to apply to these calculations. This is done in the the load case editor - scroll all the way to the right.

Dear Mr. Diehl,
thanks for Your reply.

Unfortunately yield stress is just specified, infact Flange NC-3658.3
standard report works fine.

That is what I did to create custom report:

- Select two operating load cases
- Select Flange NC-3658.3 standard report
- Option/Custom report/Edit

At this point, in Preview Report Template, I see the
preview of the first of the two load cases I selected

- I change report type from "Individual" to "Summary"

After that, Caesar 2011 preview displaies flange stress for both load
cases I selected; instead Caesar 2014 preview displaies the message
"Report contains no data to display"

- Select "Close" (X) in the upper right angle of the window

- OUTP02 asks me to save changes before exit and I select "Yes";
cause it's a protected report, OUTP02 asks me to save with different
file name, so I type "Flange Summary" and select "OK".

After that, I see "Flenge Summary" in custom report and it works fine in Caesar 2011 but not in Caesar 2014.

It seem that "Summary" report is disabled in Caesar 2014 for flange check
only, infact my Displacements summary custom report works fine.

I don't know how to attach my exported custom report file to this thread.
Thanks.
Best regards

Alessio

Right after you change the report type to "Summary", under "Flange Evaluation", try enabling "FLANGE_METHOD". Change the "Column Order" to 1. That should do it.

Thank you!
Now it works fine in Caesar 2014 too.

Caesar 2011 had no need to change this value.

Best regards

Alessio