Dear sir

i am facing problem in isometric generation . when they generate iso from default style , error coming like error in processing pcf file and when they go with tools—I-configure, error is component ssspltocx.30 missing. For this I download ssspltocx.30 and putted it into C--Windows—System32 and then run the netuser.bat file. But when I generate iso again same error is coming.
I have checked piping model in another system (WINDOWS XP )it was fine.
I am using WINDOWS 7 64 bit and CII Version is 5.3.01.

For the first error, you need to put "sssplt30.ocx" file in C:\Windows\System32 folder. For the second error, you probably need to install the Visual Fortran Runtime Library, the file you need to run is "VFRUN66AI.exe". Search the discussion forum, see if you can find them. I can also send to you by E-mail.

Regards,

Shawn Zhong
Shawn.Zhong@intergraph.com

Dear sir

regarding the first error, i have done all above thing what you are telling (downloaded ssspltocx.30 and putted it into C--Windows—System32 and then run the netuser.bat file) But when I am generating iso , again same error is coming. that ssspltocx.30 is missing.
and for second error, will you please send me VFRUN66AI.exe file. and please send me the path where i should put and run it.

Shawn,

I have the same error with the pcf file, Can you send me the VFRUN66ai.exe file ?

Thanks.

Yes. Please tell me your E-mail, you can send one to Shawn.Zhong@intergraph.com, I will reply and attach that file.

Regards,

Shawn Zhong

Dear Shawn,

I have the same problem when trying to create stress iso.
I tried it on a very simple model. I'm using Caesar 2011 5.30.01 Build 110228
Please refer to the attached screenshot.
I have downloaded and installed the vfrun66ai.exe from the following website "http://www.itl.nist.gov/div898/software/dataplot/ftp/pc/homepage.htm", but it did not help.
Could you please help me out? Much obliged.

Regards,

Danorc

Dear Sir,

i have same problem.

could you please send me Visual Fortran Runtime Library through email or send me link.

mrahmad@olayandescon.com

Open a Support Request on eCustomer and provide versioning details for your Operating System and CAESAR II. Then they can send you the correct library.

Dear All:

We had same problem (Error processing PCF file) to generate isometrics in CaesarII. I spend lot of time to find a solution an finally found it.

In our case, there was a conflict between AVEVA PDMS "environment variable" definition and CaesarII !!!!!!!

(The systems which have only CaesarII (5.1 and 5.3) , can generate isometrics drawing with no error.)

Friends,

Did you find any solution for error in pcf file?