The problem here was twofold:
1) The element length was not long enough to contain the standard radius bend expansion loop so the wizard couldn't do it.
2) The line was skewed and the loop wizard doesn't work on skewed lines (this is something we are looking at adding in the future).
#1 would work if you had the option in the loop wizard to add short-radius bends (another possible enhancement for the future).
_________________________
Loren Brown
Director of Technical Support
CADWorx & Analysis Solutions
Intergraph Process, Power, & Marine
12777 Jones Road, Ste. 480, Houston, TX 77070 USA