Could somebody please confirm there is quantity limit of steel elements by Caesar II Structural Modeler?

I just made a big structural model using Caesar II Structural Modeler. I have about 700 steel elements and I used about 700 EDIM command to model them. So each steel element was modeled using one EDIM command. (Actually all the EDIM commands lines were extracted from an Excel spreadsheet by a macro I made.) However, I found Caesar II could only handle about 500 steel elements (or 500 EDIM commands lines). All the steel elements over that quantity limit were not modeled at all.

Please confirm this restriction. Is there any recommendations? I can only use one EDIM command line to model one steel element so far.

Yes the limit is 500. Use two structural models and include them both in your piping model.

Thanks a lot, Richard.