Hello,
I am trying to increase the text size of max displacements, stresses, forces in the 3D plot of the Static Output Processor. Please advise!
Thanks,
Nick

In the graphics area, "right-Click", select "Properties". On the panel that is displayed, just below mid-way down you'll find settings for various font sizes. You will have to play with these - every graphics card behaves a little different.

I am only able to adjust Annotations, Legends, and Nodes.
I tried all three, (all which are RED colored but the text I'm trying to adjust is maroon), and it didn't change the text size or color.

you have to click "Apply"

I have adjusted the size and color and the font does not change size or color even after hitting "Apply." Is there another location where I can change the font for the Maximum forces/displacements/moments? It is extremely difficult to see.

I have no idea where it is in the Configuration Editor. But I know that the value can be changed in the registry.

If you are comfortable with Windows Registry Editor, you should be able to understand the following. If not, perhaps it's best not to mess with the registry.

Close output processor. Run registry editor, find Output Text Font Size under HKCU>Software>Intergraph CAS..... [version no]>Options. Run output processor again and check the difference. I changed mine from 12.0 pts to 36.0 pts and I got this.