How to insert Sump Head in Nozzles - Intergraph CADWorx & Analysis

You are not logged in. [Log In] Home Page » Forums » Analysis Solutions » PV Elite » How to insert Sump Head in Nozzles

Topic Options

#59751 - 07/20/14 11:19 PM How to insert Sump Head in Nozzles
Anandp Member Registered: 07/19/12 Posts: 10 Loc: India	Hi there! i am designing a LPG Bullet based on Div. 02. The problem comes when i enter an elliptical head to be used as sump for the nozzle (Dome). It gives me a warning that PVElite has encountered a problem and ask me to send the report. However, this problem is not occuring when i am designing this vessel in any other given code. Is this a problem with PVElite or am i just doing it wrong? somebody please help.
Top

#59918 - 08/03/14 06:27 PM Re: How to insert Sump Head in Nozzles [Re: Anandp]
BAIPINI Member Registered: 07/29/14 Posts: 2 Loc: NSW, AUSTRALIA	Hi, Try to check this with let's say Div.1 which I have done few times and faced no issues. So it is a good point to check your PVELITE integrity.
Top