I am using Aluminum piping throughout my model. To accomplish this, i am using Material: (14) ALUMINUM as 6061-T6 was not an option. However, when I run my error check I am receiving numerous errors of 121E and 253E
121E: Hot allowable 1 on element 10 to 20 is not specified, while the corresponding temperature is. Shx is needed for allowable calculations.
253E: On element 10 to 20 cold allowable is not specified. It is set to 0.0.
What is causing this? How do I resolve these errors?
Any help is appreciated.
Thank you,
-Drew
Edited by Apickens (06/23/14 01:36 PM)