hi every one
For pump piping having special consideration as mentioned below, the piping temp. of idle part are as follows.
Warm Up bypass Run : 90% of the operating fluid temp for the idle part
the piping to the idle pump will typically be at 50-75% of the normal design temperature. This higher than ambient temperature should be used in the flexibility analysis for the idle portions of the piping system
Steam Traced for Suction & Discharge Line : 90% of the steam temp. for the idle part
Jacketed for Suction and Discharge Line : Jacket media fluid temp. for the inner and outer pipe of the Idle part
is all state ment are correct. plz reply or share your experience.
thanks regards
a_shrivas