I am working on creation of stress isometric from CAESAR and the same will be used for stress analysis documentation. I am not able to change the following default properties. Please help me.

1. Diameter of the pipe ( If the model is in metric, I am getting diameter as 152 NS / 101 NS)

2. Elevation (By default elevation is taken as 0.0 at the starting point irrespective of global co-ordinates)

Thanks and Regards

I'm not sure what you mean by #1, everything should convert to your model's units. 152MM should be a 6" OD. ISOGEN converts everything to an integer, and it doesn't try to convert to a standard pipe size. We're hoping to do the work for them in version 5.10.

Elevations at the origin are always set to zero, although other global coordinates should be OK (assuming ISOGEN doesn't complain about disconnected pipes). I'll have to check and see if there's anything we can do to set the origin somewhere other than 0,0,0...

Regards,

- David Little
- COADE, Inc.
- Houston, TX