I want to model a gussel support on the inside of a pressure vessel to support the internal coils. Is it possible to model on the inside of vessel in pvelite? and can I put in user-defined loads for WRC calculations?

I tried using the lug support command to model this but it would not let me model on inside of vessel. It also let me select to run WRC calculations but it did not let me enter in my own loads. It ran it for the weight of the vessel.

As per my knowledge, it is not possible in PV Elite.

You should get clarification from the people you paid for this clarification;- look up the moderators of this forum. They might be too busy to help you.

You should get clarification from the people you paid for this clarification;- look up the moderators of this forum. They might be too busy to help you.

For WRC Calculation related with clips and user defined loadings, you can use clip option in PV Elite.

But I doubt whether you can apply the same to inside of vessel.

Thanks.

Mukesh Chopra
theculminates@yahoo.com
+91-9428500192