When modeling dual certified 304/304L, can you use either the 304 or the 304L allowables for up to 1000°F? I read an interpretation (1990) that indicates the below 1000°F you can use both, but above you must use the 304L allowables. Is this stil true? Any other information I should know when modeling this material?
I believe iI have read about this in a previous post, however, when i do a search, it finds so mnay hits, it is easier to ask and not spend all of my clients tims here!
Thanks!
_________________________
"Just because you haven't done it doesn't mean it is impossible"