Dear all,
Can anyone tell me how to model the pump suction and discharge line together in one model?
Your reply awaited.
Thank you very much.
Please help me out.

Thanks and regrads.

Just code it it as you would any other system of pipes.

Model the pump body as rigid elements from nozzles to anchor point.

thank you Moverz.

yes I modelled the pump body as rigid but I want to join the suction and discharge line.
So how I can model the line near the pump suction and discharge nozzle?
I hope my question is clear to you all.

Thanks and regards,

What is the problem ? Just do the input.

If you want to make a really nice job of it, use Cnodes at the nozzle faces to easily identify nozzle loads in the output reports.

hi peterson,

ur question is how to model pump suction and discharge as one,
ur answer for this is ,
model the pump nozzle with cnode anchore and go till center of pump and model dischagre as well ,it should be connecting and with one anchore .

Juice,

Why have you repeated exactly what I wrote on 16th and 20th November ?

Hi MoverZ,
I just want to tell him that to model the anchor as one.
since i had done mistake when i was doing that type of job.

Sorry if it hurt you.

Didn't hurt, just a waste of time.