Hi,

I am trying to drawing threaded flanges but i am getting a warning dialogue box "current specification and configuration does not allow this size, cancel only".

My main size is set at 2 and my red size is set at 1. I have also tried main size set at 1.

It was working in cadworx 2010 but not in cadworx 2012.

Thanks,

Customupstream

Do you have any pipe defined at 1"?

Yes i do.. i have attached a chart showing my optional items for pipe.

Thanks,

Custom Upstream

Does drawing threaded flanges work when you use the Inch-CS-2013.prj?

Hi TBS,

I'm not sure what you mean by "Inch-CS-2013.prj"

Thanks

In the setup dialog is the radio button for threaded selected (as opposed to socket weld)?

Hi Cadmunkey,

its set up to threaded in the setup dialog box.

Thanks

Custom Upstream

I did not notice you were having this problem in 2012, not 2013.

I guess my question should have been:

Have you tried running this with a out of the box CADWorx specification and do you get the same results?

Hi TBS,

It works using the default cadworx spec. I just can't figure out why my custom specs doesn't work.

Thanks,

Custom Upstream

Can I see your data file for the flange?